View Single Post
Old 10-10-2012, 19:12   #2
MrVvrroomm
Senior Member
 
MrVvrroomm's Avatar
 
Join Date: Feb 2009
Location: Shakopee, MN USA
Posts: 3,282
No, a Gen3 magwell will not fit any Gen4. The insert goes in the slot in the rear of the frame. This area is much smaller on the Gen4 guns.

With the Glockworx magwell you cannot run any additional backstraps.

Check your PM's.
__________________
May I assume you're not here to inquire about the alcohol or the tobacco?

Certified Glock Armorer
MrVvrroomm is offline   Reply With Quote