View Single Post
Old 10-10-2012, 07:18   #39
Southwind
Senior Member
 
Join Date: May 2012
Location: Southwest Indiana
Posts: 119
Quote:
Originally Posted by dhgeyer View Post

... I intend to do my experiment with one of the non-dip Glock ones as soon as they arrive. What I'm going to do is remove material from the edge of the claw to make it parallel with the opposite side of the slide, recut the groove and trim the front of the claw as needed, and then take a bit off the pad, but just enough to keep tension on the case. Since there is already tension on the case in the linked down position, I don't think I'll need to take .012" off the pad: probably more like .002"to .004". I will then make a new SLB to put more tension on the claw and move the EDP forward to compensate for the material I have removed. ...
Have you looked at a non-LCI extractor? Sounds like that's what you're going to make.
Southwind is offline   Reply With Quote