View Single Post
Old 10-09-2012, 19:57   #32
molar
Senior Member
 
Join Date: Apr 2007
Location: TN
Posts: 384
I detail stripped my gen 3 17, gen 2.5 26, and problematic gen 3 19 slides and measured from the front edge of the extractor channel to the opposite external surface of the slide. There were no appreciable differences in the dimensions. I don't think the problem lies with the depth of the extractor channel. I still think the extractor is situated too far from the breechface. Due to the angle of the cut in the slide, it appears that filing down the extractor pad per Dave's recommendations would not only apply more biting force to the case rim, but would also swing the extractor in towards the breechface a little. The pad that needs filing is 0.023" on my extractor. I think I'll take off 0.012 and see what it does.
molar is offline   Reply With Quote