View Single Post
Old 10-03-2012, 07:19   #7
MNBud
Senior Member
 
MNBud's Avatar
 
Join Date: Feb 2007
Location: suburb of Mpls. Mn.
Posts: 760
Do exactly as RM686 suggested, it is usually the second thing I do to my Glocks after installing TruGlo sights. I put the trigger in the fired position and then use a half round jewelers file to bring the tab flush with the rest of the trigger and then sand it and the ribs with 400 grit emery and then 600 grit. The sanding takes the sharp edges off but doesn't remove a noticeable amount of material. This is a huge improvement and will not affect the operation of the safety. (which in my mind is a joke to start with).
__________________
Just because you know you're paranoid doesn't mean someones not out to get you.

Sub club #622
Certified Glock armorer
MNBud is offline   Reply With Quote