View Single Post
Old 09-24-2012, 14:57   #10
Remington 870
Senior Member
 
Join Date: Feb 2012
Posts: 150
well i have a Glock 20sf and it runs good thus far. One thing I found was when I detailed stripped it to do the 25 cent trigger job I found filling's and loose sandy crud in the extractor area when I was removing the slide internals to polish the tang on the striker. I used dish soap and a cue tip to clean out the small areas. we used to wash down engine blocks after machining them with hot soapy water so it works well to remove loose metal filings etc. hope this helps, my gun ran great before I detail stripped it but it was interesting to find all that crud in that area. hope this help's.
Remington 870 is offline   Reply With Quote