View Single Post
Old 08-01-2012, 21:32   #6
walrus108
Senior Member
 
walrus108's Avatar
 
Join Date: Feb 2006
Location: Georgetown, TX
Posts: 957
Send a message via AIM to walrus108
Thanks for that warning taterhead. My suspicions are confirmed. When I started seeing starting loads that varied by more than 1.5grains, it for sure throws up some red flags. Inconsistant batches, or at least a considerable change in formula over the years, must be the reason. I even have the 'one book/one caliber' book where the 10mm IMR data is partially whited out. From an older copy, I was able to see a max load of 9.7grains under a win JHP 180gr with a velocity of 132? (whited out). They had also listed a load of 14.5grains for the Nosler 135gr at 1670fps! I guess they are no longer standing behind those loadings.

Is it safe to download to 8.0 grains of 800x? I know some powders, like BD, will cause pressure problems also if you start too low. If not, 8.0 will be where I start. Better safe than sorry. I would like to use this 800x, so many 10mm guys rant about how great it can be, but it has me very leery. I'm going to contact IMR and see what they have to say about all this. Maybe I'll use my match witness to build some loads with it, but I'm probablly going to stick with Bluedot for these XTP's I want to load. I like my guns and my fingers!

Anybody want to buy a sealed can of 800-x? 2lbs seems like too much of it for me right now!
__________________
There are two ways to slide easily through life; to believe everything or to doubt everything. Both ways save us from thinking. -Alfred Korzybski

Last edited by walrus108; 08-01-2012 at 21:36..
walrus108 is offline   Reply With Quote