View Single Post
Old 02-23-2012, 00:20   #58
DJ Niner
Moderator
 
DJ Niner's Avatar
 
Join Date: Feb 2001
Location: North-Central USA
Posts: 17,309
Quote:
Originally Posted by NDGlock View Post
Intrigued now....what did you get if you don't mind me asking?
The model 469 9mm recall was for a problem with the safety lever and half-cock notch potentially leaving the hammer in an unsafe position after a partial manual cocking or partial DA trigger pull.

The model 586 .357 recall was the hammer-nose and/or hammer-nose bushing (surrounds the little hole where the hammer-nose (firing pin) passes through the frame and strikes the primer). If the bushing sunk below the level of the surrounding frame, primers could back-out slightly on firing, binding the cylinder (really tight).

The first and forth recalls shown on the page linked below:

http://firearmsid.com/Recalls/FA_Recalls%205.htm


.

Last edited by DJ Niner; 02-23-2012 at 00:25..
DJ Niner is offline   Reply With Quote