Thread: 9mm/40 ejector
View Single Post
Old 10-09-2011, 21:35   #2
JR
GT Sponsor
 
Join Date: Dec 1998
Location: Oldtown Idaho USA
Posts: 3,936
Send a message via AIM to JR Send a message via Yahoo to JR
The 9mm ejector is long and bent. The 40 ejector is long and straight.
The 40-9 conversion barrels are exactly that CONVERSIONS. They are made to work with the 40 parts.

If you start switching ejectors around you will notice the 9mm ejector hits the base of the cartridge just outside the primer. This could result in an open breach detonation when ejecting a loaded round.
You are correct, an 11lb spring is barely enough to reliably cycle the slide HOWEVER current 115 gr ammunition is BARLEY enough to cycle the slide. If you insist on shooting weak ammo you will be forced to use weak springs.

Hint: Use quallity ammo and be done with it!
__________________
www.lonewolfdist.com

Last edited by JR; 10-09-2011 at 21:36.. Reason: spell
JR is offline   Reply With Quote