Thread: LW connector
View Single Post
Old 10-03-2011, 10:00   #4
JR
GT Sponsor
 
Join Date: Dec 1998
Location: Oldtown Idaho USA
Posts: 3,940
Send a message via AIM to JR Send a message via Yahoo to JR
You want to make sure the connector leg is properly seated in the trigger housing. If the connector was bent inward you will be able to correct the angle by placing it upside down on a hard surface and tapping on the angle. This will open it up and create more pressure on the slide
__________________
www.lonewolfdist.com
JR is offline   Reply With Quote