Glock Talk - View Single Post

Shasta McNasty · 07-07-2011, 00:37

i've been completely unimpressed with the quality of the finish on any of the glock exo's i've seen. looks like a union worker with a paint gun applied it. i've even seen excess "fail zero" globbed up in the slide rails.

the barrels weren't even finished at all as advertised but rather just had the stock finish stripped off and there were still traces of original finish all over.

this thread just confirms my thoughts: pass.

i'd try to get exo to remedy it, then sell it. it wouldn't surprise me if they stripped the surface down far enough that they removed the tenifer treatment.

07-07-2011, 00:37	#14
Shasta McNasty Senior Member Join Date: Jun 2011 Location: deluxe apartment in the sky Posts: 1,261	i've been completely unimpressed with the quality of the finish on any of the glock exo's i've seen. looks like a union worker with a paint gun applied it. i've even seen excess "fail zero" globbed up in the slide rails. the barrels weren't even finished at all as advertised but rather just had the stock finish stripped off and there were still traces of original finish all over. this thread just confirms my thoughts: pass. i'd try to get exo to remedy it, then sell it. it wouldn't surprise me if they stripped the surface down far enough that they removed the tenifer treatment. Last edited by Shasta McNasty; 07-07-2011 at 00:45..