View Single Post
Old 12-20-2010, 05:30   #17
Alcoy
Senior Member
 
Alcoy's Avatar
 
Join Date: Jul 2006
Location: Virginia
Posts: 1,274
Quote:
Originally Posted by ydduit View Post
I used a little Bernzomatic butane pen torch and heated the hump till it was pliable. I then pressed it against a flat surface to flatten the back of the grip out.
ydduit, looks very good.

when you did the above process, did it affect the original finish? i would like to get rid of the hump, but keep the original finish on my glock. i heated the a couple of kydex holsters to change the sight channel and the grip cover; but worried about doing it on a gun. the kydex jobs i did, did not look professional job at all. nothing like yours.

any advice is greatly appreciated. thanks in advance.
Alcoy is offline