View Single Post
Old 01-11-2010, 17:31   #13
glocktalk1
Registered User
 
Join Date: Jan 2010
Location: USA
Posts: 16
The rear guide rod is correctly seated. The slide lock is correctly installed. The spring on the slide release is installed under the locking block pin.

In addition to pushing down on the slide locks to bring the slide "home", lifting up on the front of the slide also seems to work. If I let the slide rest on the frame / receiver while sliding back, it gets "stuck" about a half inch from normal position. Lifting up on the front of the slide or pressing down on the slide lock is the only way I can bring the slide "home" I am guessing it has something to do with the barrel machining where it makes contact with the slide lock? At any rate, is this normal and will my new G26 "get better with age" and if not should I bring her back to my FFL? TIA!
__________________
"The war is coming to the streets of America and if you are not keeping and bearing and practicing with your arms then you will be helpless and you will be the victim of evil." - Ted Nugent

Last edited by glocktalk1; 01-11-2010 at 17:46..
glocktalk1 is offline   Reply With Quote