Glock Talk - View Single Post

Retired Squid · 11-29-2008, 21:43

Chuck I walked into gun shop this morning and bought a 686-6 Power Ported SER# DBF26XX is this a 2006 made gun?

It appeared to be NIB with the 3 cylinders fired at factory and never fired again. It didn't have a turn ring when I first looked at it about 6 months ago in the shop, but has a very slight one from every time I have looked and worked the action as did a few other I am sure. I will know for sure once I pull side plate and cylinder tomorrow, but what is the odds this gun has been hanging around for about two years?

Any info you can provide about the gun I would be most grateful. Thanks in advance. Yes I will post pictures later in the week after new Pachmyr grips and a little cleaning a waxing.

11-29-2008, 21:43	#38
Retired Squid Senior Member Join Date: Jul 2007 Location: SwampeastMO Posts: 878	Chuck I walked into gun shop this morning and bought a 686-6 Power Ported SER# DBF26XX is this a 2006 made gun? It appeared to be NIB with the 3 cylinders fired at factory and never fired again. It didn't have a turn ring when I first looked at it about 6 months ago in the shop, but has a very slight one from every time I have looked and worked the action as did a few other I am sure. I will know for sure once I pull side plate and cylinder tomorrow, but what is the odds this gun has been hanging around for about two years? Any info you can provide about the gun I would be most grateful. Thanks in advance. Yes I will post pictures later in the week after new Pachmyr grips and a little cleaning a waxing. __________________ Rimfire for plinking, 357 Magum for paper, 10mm for when 45ACP isn't enough and 44 Magnum for everything else.