Glock Talk

Glock Talk (http://glocktalk.com/forums/index.php)
-   Gunsmithing (http://glocktalk.com/forums/forumdisplay.php?f=23)
-   -   Glock 22 Gen 4 Slide Lock (http://glocktalk.com/forums/showthread.php?t=1470524)

wolf2223 02-08-2013 13:47

Glock 22 Gen 4 Slide Lock
 
I recently purchased two Gen 4 22. I believe there is a problem. Both of them with the magazines OUT of the weapon slide lock. I have not fire either one yet but they should not slide lock without a empty magazine. Has anyone seen this problem. I have some dummy rounds that I picked up and going to run the slide manual and see if it is going to lock even with a loaded mag. :steamed::steamed:

Bigpoppie50 02-08-2013 13:57

My Gen4 G22 slide will not lock back if a magazine is not in the gun unless I manually push the slide catch up when moving the slide rearward.

jdsumner 02-08-2013 15:50

wolf,
is there any chance the slide lock lever has been installes with the spring arm on top of the pin, and not under it?

dan

cciman 02-08-2013 15:52

Were these used guns from the same seller?

If you know how to details strip the frame, check the install of (and the spring) on the slide release. The lever should have some spring tension snap, lay flat against the frame, and have a small amount of fore/aft play.

If you don't know how, then do some research, watch Youtube, and learn now.

wolf2223 02-11-2013 14:59

Both are NIB
 
The spring had way to much tension. I disassembled them and adjusted the spring and now they are golden. thx for the replies.


All times are GMT -6. The time now is 12:15.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2013, Glock Talk, All Rights Reserved.