Glock Talk

Glock Talk (http://glocktalk.com/forums/index.php)
-   Black Rifle Forum (http://glocktalk.com/forums/forumdisplay.php?f=93)
-   -   Hypothetically Speaking. (http://glocktalk.com/forums/showthread.php?t=1467084)

Fwdftw 01-24-2013 12:21

Hypothetically Speaking.
 
If i installed my dynacomp in a vice with shop towels holding it in there.. AND JUST SAY i hypotehtically gouged the barrel a little with a scratch.. How would one repair this? :whistling::whistling: The person that did this :whistling: doesnt care as its a shooter and not a wall hanger.. How would he prevent rust etc? High heat paint? The same he put on his gas block when he cut it down to make it Lo Pro? Just looking for advice.. it certainly wasnt me that did this :supergrin:

Picture
http://i31.photobucket.com/albums/c3...124_140327.jpg

Travclem 01-24-2013 12:35

I have never had rust on the bare spots that were under the FSB on any of my ARs. I'd just oil it and leave it alone.

Fwdftw 01-24-2013 12:37

Ill post a picture when i get out of work.

posted using Outdoor Hub Campfire

Matthew Courtney 01-24-2013 12:56

Corrosion X works for us when we duck hunt with blued Remington 1100's in the salt marsh where salt spray and water dripping of of pirogue paddles gets salt water on everything.

Batesmotel 01-24-2013 13:00

Quote:

Originally Posted by Travclem (Post 19905585)
I have never had rust on the bare spots that were under the FSB on any of my ARs. I'd just oil it and leave it alone.

This. I have scratches on my ARs and my issued M16-A1 was a mess. Just clean and oil.

Fwdftw 01-24-2013 14:10

Picture http://i31.photobucket.com/albums/c3...124_140327.jpg

posted using Outdoor Hub Campfire

WoodenPlank 01-24-2013 17:19

Obligatory: Dumbass.

Cold blue, aluminum black pen, high heat engine paint, stove/radiator paint, etc - any one of those should work. My vote would be the high heat engine or stove paint, personally.

Fwdftw 01-24-2013 17:50

Yup just did that plank.. this was a ***** to time with that crush washer.. i went just a hair over but im sure it will work fine? Yes? Order another washer and get it perfect?

posted using Outdoor Hub Campfire

lawman800 01-24-2013 23:52

Sharpie.

themighty9mm 01-25-2013 01:42

Alumablack should do the trick. Dispite the name it works on steel aswell. I put some on touch up spots that never realy see oil and see moisture at times. Havnt had a problem yet


All times are GMT -6. The time now is 16:38.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2013, Glock Talk, All Rights Reserved.