I finally bit the bullet!!!
 

I did it I got a reloading setup. I am so excited to start turning out rounds.
Here is my setup let me know what you think. Keep in mind i'm just starting out so go easy on me.
Press: Lee 4 hole turret w/ auto index kit scale powder dump $100
Tumbler: Cabela's 400 Kit $55
Lee Modern Reloading Manual: $15
Hornady Headspace Gauge: $40
Lee .357 Sig Steel 3 Die Set: $26
Lee .357 Sig Factory Crimp Die: $19
Electronic Caliper:$19
Bullet Puller $12
Lube and Pad $13
Loading Block $9
Total with shipping $341

You don't need the loading block. I would get a better loading manual. I would try Hornady one shot lube first instead of of lube and pad.
:welcome:

You can ditch that. For a few more bucks, you can opt for a Lee Pro auto disk and a powder measure riser.

Press: Lee 4 hole Classic Turret w/ auto index kit scale powder dump $212 (from Kempfs, comes with dies)
Tumbler: Cabela's 400 Kit $55
Lyman Reloading Manual: $15
L.E. Wilson Case gages: $25 (From Dillon USA)
Lee .357 Sig Factory Crimp Die: $19
Electronic Caliper:$19
Bullet Puller $12
Hornady One Shot/Dillon Lube. $8
Dillon Eliminator Scale. $55

Total about $420

Much, Much better scale, same dies, better manual, good case gauge, eliminated stuff you don't need.

I know it's more but it's a lifetime investment and it's only another $100

Beam scales? Ha!

congrats. enjoy the new addiction.

I didn't realize you already ordered?

Real men use beam scales.

I use a cheap old Redding scale that I bought new in the early 1980's. Just last year I got bored and decided to check it using various weights and a NIST calibrated precision digital scale that we have at work. My beam scale is accurate to better than .2% from 2 grains to 35 grains.:tongueout:

I have the hornady headspace gauges.
They work good.
Not much to them though.
A must have IMO.

I would suggest returning the lube & pad, FCD.
This
http://www.midwayusa.com/viewProduct...tNumber=204960
http://media.midwayusa.com/productim...204/204960.jpg
and this goes super fast and really far!
http://t0.gstatic.com/images?q=tbn:A...BcN3HDlInrmaIw

While I am running through about 11K in 5.56 right now. I use 2 shots on the pan, cover it in 1 layer of brass, shake the pan for 10 seconds, dump in case feeder, done!

I think you made a terrible mistake by not reading the sticky.